Mortise and Tenon Joint with a Router
How to cut a mortise and tenon joint with a router, covering bit choice, router table and edge guide setups, and safe shop practice for tight joints.
Contents
- Choosing bits for router mortising
- Setting up a router table
- Using an edge guide for tenons
- Questions about router mortise and tenon joints
- Can a router cut both the mortise and the tenon?
- What router bit should I use for mortising?
- Is a router table necessary for this joint?
- How do I get a tenon that fits without forcing?
A mortise and tenon joint with a router is cut by removing the socket (the mortise) and shaping the matching tongue (the tenon) with a spinning bit guided by a fence or jig. The router gives you repeatable depth and a clean shoulder when the stock is clamped firmly and the passes are light. This page explains the bits, the setups and the checks that keep the joint square and tight. It assumes the workpiece is secured and that you have practiced on scrap before touching a finished piece.
Choosing bits for router mortising
Router mortising works with an upcut spiral bit or a straight bit that matches the tenon thickness. A spiral bit clears chips upward and leaves a flat-bottomed mortise, which suits a square-ended tenon. Choose a bit diameter slightly smaller than the finished mortise width so you can take two or three passes. Plunge slowly, and let the bit come to full speed before it touches the wood.
Setting up a router table
A router table turns the router upside down so the workpiece rides on a stable surface with a fence for control. Set the fence parallel to the bit and mark the mortise position on the stock before the first pass. Raise the bit in small steps and run the piece against the fence with a push block. The table gives repeatable depth, which matters when several mortises must align.
Using an edge guide for tenons
An edge guide clamps to the router base and references the side of the workpiece, so the tenon cheeks come out parallel. Cut the cheeks first, then remove the waste between the shoulders in successive light passes. Check the fit against the mortise after each pass rather than removing too much at once. A tenon that needs force to enter will split the mortise walls, so aim for a snug sliding fit.
Questions about router mortise and tenon joints
Can a router cut both the mortise and the tenon?
Yes, a router can cut both parts of the joint when you use the right bit and a guide. The mortise is routed with a plunge or spiral bit inside marked limits, and the tenon is shaped with the same bit working against a fence or edge guide. Matching the bit to the tenon thickness keeps the two parts consistent.
What router bit should I use for mortising?
An upcut spiral bit is the practical choice for router mortising because it lifts chips out of the cut and leaves a clean bottom. A straight bit also works when you take light passes and clear the waste between them. Pick a bit diameter a little under the mortise width so you can clean up the walls on a second pass.
Is a router table necessary for this joint?
No, a router table is not required, but it makes the mortise cuts easier to repeat because the fence and the table surface hold the work steady. You can cut the same joint with a handheld router and an edge guide, taking care to clamp the stock and keep the base flat. Choose the setup that gives you control over depth and direction.
How do I get a tenon that fits without forcing?
A tenon should slide into the mortise with light hand pressure and no wobble. Sneak up on the fit by removing small amounts and testing after each pass, since removing too much cannot be undone. Mark the shoulder line clearly and stop the cut there so the joint closes tight against the face.