# How to use a fermentation jar with an airlock

Set up an airlock jar for anaerobic fermentation, fill the airlock to the right water level, seal the lid, and keep Thai fermented sauces safe.

To use a fermentation jar with an airlock, pack the food below the brine, fit the lid with its gasket seated, and fill the airlock to its marked line so gas escapes while outside air stays out. The airlock does the burping for you, which keeps the environment anaerobic. Check the water level and the brine every few days until the ferment is ready. 

- Fill the airlock to its fill line with water so it bubbles instead of letting air back in.
- Keep the food under the brine with a weight, since contact with air invites mold.
- Seal the jar by seating the gasket and closing the lid fully before fermentation starts.
- Watch the airlock for bubbles as a sign that gas release is happening.
- Top up the airlock water when it drops, or the seal stops working.
 

## What the airlock jar does 

A fermentation jar with an airlock creates anaerobic fermentation, meaning the food ferments without oxygen. The lid seals the jar, and the airlock holds a small pool of water that lets gas out but blocks air from coming back in. 

Gas release happens on its own as the ferment produces carbon dioxide, so you do not need to open the jar to burp it. A burping jar, by contrast, must be opened by hand to release pressure, which lets air in each time. 

[Thai fermented sauces](/articles/an-introduction-to-thai-fermented-ingredients-and-foods/) such as nam pla prik or fermented soybean sauce benefit from this steady, oxygen-free environment. The airlock jar is a fermentation vessel with a one-way valve on top, and that valve is the whole point of the setup. 

## Setting up the jar and lid 

Lid placement matters more than force. Set the gasket into the lid groove, place the lid on the jar, and close it fully so the seal is even all around. 

Check that the airlock stem sits snugly in its grommet or stopper. A loose stem leaks gas around the sides and defeats the seal. Press the airlock down until it sits firm and upright. 

Sealing the jar comes before you fill the airlock, since a dry airlock during packing invites air movement. Once the lid is closed, the jar is ready for the water step. 

## Filling the airlock to the right level 

Airlock water level decides whether the valve works. Fill the airlock with clean water up to the line molded on its side, which leaves room for bubbles to pass. 

Too little water leaves a gap that outside air can cross. Too much water can bubble into the jar or spill when the ferment foams. The fill line is there for a reason, so trust it. 

Some cooks use a mild sanitizer solution in the airlock instead of plain water. Either way, keep the level steady and refill it whenever evaporation or bubbling lowers it. 

## Packing food under the brine 

Anaerobic fermentation only works when the food stays submerged. Pack the vegetables or sauce ingredients into the jar, then add brine until the liquid sits above the food. 

A weight holds the food down, because pieces that float above the brine can grow mold. Glass weights, a sealed bag of brine, or a folded cabbage leaf under the weight all do the job. 

Leave headspace below the lid for foam and expansion. A jar filled to the brim pushes brine into the airlock when the ferment gets active. 

## Watching the airlock while it ferments 

Bubbles in the airlock show that gas release is working. A steady trickle of bubbles means the ferment is active and the seal is holding. 

No bubbles can mean the ferment is slow, the jar is cool, or the lid is not sealed. Press the lid down again and check the gasket before you assume anything is wrong. 

Keep the jar out of direct sun and away from strong temperature swings. A steady, moderate spot lets the ferment proceed without stalling. 

## Daily checks that keep the seal working 

Check the airlock water level every day or two. Evaporation and bubbling both lower it, and a dry airlock lets air into the jar. 

Look at the brine through the glass. If the food has risen above the liquid, push it back down with a clean utensil or add more brine. 

Inspect the lid and gasket for residue or cracks. A gasket that is tacky or torn will not seal, and no airlock can fix a leaking lid. 

## Opening the jar without spoiling it 

Open the jar only when you need to taste or check the ferment. Each opening lets air in, so keep the visits short and close the lid right after. 

Take the airlock off gently and set it aside upright. Refill it to the line and press it back in before you close the lid again. 

If you move the ferment to a plain jar for storage, keep the food under brine and use a tight lid. The airlock is for active fermentation, not for long keeping. 

## Problems and how to read them 

Mold on the surface means the food touched air. Remove the affected layer and check the brine level, then weigh the food down better. 

A cloudy brine with a sour smell is normal in a working ferment. Fuzz, slime, or a rotten smell means the batch has gone wrong and should be discarded. 

Brine pushed into the airlock means the jar was overfilled. Clean the airlock, refill it to the line, and leave more headspace next time. 

## Questions About Airlock Fermentation Jars 

### How do you use fermentation lids with an airlock? 

A fermentation lid works the same way as an airlock jar top. Seat the gasket, close the lid fully, and fill the airlock to its line with water. The lid then lets gas out and keeps air from getting in. 

### Do you need to burp a jar with an airlock? 

No, an airlock jar does not need burping because the valve releases gas on its own. A plain burping jar must be opened by hand to release pressure. The airlock replaces that step with a one-way water seal. 

### What happens if the airlock runs dry? 

A dry airlock stops working as a seal and lets outside air reach the ferment. Check the level every day or two and top it up to the fill line. Keep the lid closed while you refill it. 

### How full should the airlock be? 

Fill the airlock to the line molded on its side. That level leaves room for bubbles to pass through the water. Overfilling or underfilling both weaken the gas release. 

### Can you use an airlock jar for Thai fermented sauces? 

Yes, an airlock jar suits Thai fermented sauces and pastes that ferment without oxygen. Keep the mixture under its brine or liquid and leave headspace for foam. The airlock handles the gas while the sauce develops.
