# Calculating clay shrinkage percentage: formula and calculator

Learn the clay shrinkage formula and how to use a clay shrinkage calculator to size wet clay pieces so they finish at the dimension you want.

Clay shrinkage percentage tells you how much a piece gets smaller as it dries and fires. You measure the original wet length, measure it again once it is dry or fired, and compare the two numbers. This page gives you the shrinkage formula and shows how a clay shrinkage calculator uses it to size work in pottery sizing. 

## The linear shrinkage formula step by step 

The shrinkage formula is simple subtraction followed by division. You take the original length measurement minus the final dry length, then divide that difference by the original length. Multiply by one hundred to turn the result into a linear shrinkage percentage. A piece that starts at a measured length of ten units and ends at nine units has a shrinkage rate of ten percent. 

## Reading wet and dry dimensions 

A shrinkage reading is only as good as your wet and dry dimensions. Mark two points on a soft clay bar and record that distance before the clay stiffens. After drying, or after firing, measure the same two points again with the same rigid tool. Comparing the original length measurement to the fired length shows the clay shrinkage rate. 

## Working a calculator in reverse for sizing 

A clay shrinkage calculator lets you size a piece before you build it. You enter the shrinkage percentage and the finished dimension you want, and the tool divides the finished size by one minus shrinkage as a decimal. A shrinkage calculator app that runs free on a phone is enough for this job. Check the wet-to-dry result against a fired test tile before trusting it on a large piece. 

## Clay shrinkage percentage questions 

### How do you calculate shrinkage in clay? 

You calculate shrinkage in clay by subtracting the dry length from the wet length and dividing by the wet length. Multiply the result by one hundred to express it as a percentage. Measuring the same marked points each time keeps the clay shrinkage calculation honest. Repeat the test on a small bar of the same clay body. 

### What is the clay shrinkage percentage calculation from raw dimensions? 

Clay shrinkage percentage calculation from raw dimensions uses two numbers only, the wet length and the final length. Divide the difference by the wet length and multiply by one hundred. A fired reading often differs from a dry reading, so label which stage your figure covers. Keep the two recorded measurements with your notes. 

### Is there a free clay shrinkage calculator app? 

Yes, a free clay shrinkage calculator app exists for phones and browsers. A basic shrinkage calculator needs only the percentage and one known dimension. Read which units the app expects before you type a number. Any calculator you use is only as reliable as the shrinkage figure you feed it. 

### What is the clay shrinkage formula for a desired fired size? 

The clay shrinkage formula for a desired fired size divides the target size by one minus the shrinkage rate as a decimal. With a ten percent rate, you divide the target by zero point nine. This reverse step is where the shrinkage calculator saves the most time. Confirm the rate on a test piece when the form is large.
